Filter
Top Products
ZIGZAG STiTCHiNG
SETTINGS :Presser foot- General Purpose Foot
:Thread tension control - AUTO
The top thread may appear on the bottom depending on the
thread, fabric, type of stitch and sewing speed, but the bobbin
thread must never appear on the top of the fabric.
If bobbin thread is pulling to the top or you are experiencing
Puckering, slightly reduce the tension with the Thread Tension
Control.
Under side
C6te de
Reverso
Top side
C6te de dessus
Cara
ADJUSTING STITCH WIDTH AND LENGTH
Dark grey box indicates the Auto/default value set
automatically when the pattern is selected.
For the Zigzag Pattern the stitch length is 2 mm and the
stitch width is 5 mm.
[_ The light boxes indicate alt the possible personal
grey
preference options available to set manualy.
Note: The values shown in the chart are actual sewing
lengths and widths and do not correspond to the scale and
number markings on the sewing machine.
SATIN STITCH
This is a closely spaced attractive stitch for applique, bar-
tacking, etc. Slightly loosen the top thread tension and manually
adjust the stitch length between 0.5 and 2.0 for satin stitching.
Use a backing of stabilizer or interfacing for sheer materials to
avoid puckering.
PLACEMENT OF PATTERNS
Stitch width of pattern increases from center needle position as
illustrated.
38
$
>
b
z
o
-J
STITCH WIDTH
LARGEUR DU POINT
ANCHO PUNTADA
mm 2.0 2.5 3.0 3.5 4.0 4.5 5.0 5.5 6.0
0 " " " " " " " "
0.25 I I I I I I I I
0.5 I I I I I I I I
I I I I I I I I
0.75
I I I I I I I I
1.0
I I I I I I I I
1.25
I I I I I I I I
1.5
I I I I I I I I
1.75
2.0 J J J J J I
2.5 I I I I I I I I
3.0 I I I I I I I I
Center position
Position centrale
Aguja posicionada en et centro