Filter
Top Products
SECTION 2. PREPARE YOUR MACHINE FOR SEWING
o Cf_eck YaurPresser Foot
Your presser toot Is held in place by a Foot Holder. Each presser toot
merely snaps on the toot holder, which is seldom removed.
If you need to remove or attach the toot holder, here is what you do:
To Remove:
Foo_
To Attach:
To Remove:
Turn the screw toward the back Of I.
tile maehine. Use the large screw
driver.
2.
To Attach;
Match the hole in the toot
holder with the threaded hole
in the presser bar,
Fit the lOOt holder screw _nto
the hole.
3. Tighten the screw by tumm 9 _t
toward you.
o Change the Presser Foot
Use the correct presser toot _or the stitch Yoo wish to sew. Consult the Stitch Pattern
Chart and the detailed directions _or sew_n_j with the varloUs presser _eet.
To snap o|f :
1_ p/DOw
b_tten
meyer
To Snap On:
To Snap Off the Presser Foot:
l, Press the Up/Down Needle PosLtion Button
to raise the needle to _ts highest position.
2, Raise the presser toot_
3, Press the red button on the back ot the toot
bolder. The presser tOOt will drop oil,
To Snap On the Presse_
Foot:
h Set the Pressure Dial at
2+ Place the presse_ toot
So tire hor+zonta! pm on
the _oot lies lust under
the groove ot the toot
holder.
3, Lower the presser foot
bolder to lock the
presser toot m place.
NOTE: If you do not hear the presser toot soap _o place, press down on the presser
_ioot holder firmtv until you hear the snap.
t5