Filter
Top Products
SC
93
(c) Automatic zone registration using the system
controller (SHA-KC64UG)
(1) Press the
and buttons at the same
time for more than 4 seconds.
and CODE No. C1 will flash.
(2) Select CODE No. C2 by pressing
and
( ) button and press the button.
C2 changes from flashing to ON state and
automatic zone registration will start.
(3)
(4) Central address will be assigned from the smallest
indoor unit address to larger ones in numerical
order automatically.
On finishing automatic zone registration,
changes from flashing to OFF.
(5) If an error occurs, “CHECK” starts
flashing and zone registration finishes at this
time. Press the button to start over.
(6) Finally, complete automatic zone registration
mode by pressing the button.
flashes for a few minutes, then turns OFF.
Fig. 8-10
Any registered GROUP Nos. will be erased.
07-115 SSHP_II 5/7/07 4:00 PM Page 93