Filter
Top Products
SC
90
8-5. How to Perform Zone Registration
To operate the system controller properly, zone registration is required after finishing the test run (and after
setting all indoor unit addresses) using one of the following methods.
(a) Zone registration using the remote controller (RCS-SH80UG)
Refer to page 91.
(b) Zone registration using the system controller (SHA-KC64UG)
Refer to page 92.
(c) Automatic zone registration using the system controller (SHA-KC64UG)
Refer to page 93.
For methods (a) and (b), you should make a zone registration table manually before performing the
registration as shown on the next page.
For method (c), zone registration is executed automatically, proceeding from the smallest indoor unit address and
smallest central addresses to larger numbers in numerical order. For example:
An indoor unit address is assigned to each indoor unit during automatic address
operation. Each indoor unit address combines an R.C. address and indoor unit number
as follows:
This address is displayed on the remote controller for UNIT No. when the UNIT
button is
pressed.
1.
2.
The central address represents the zone and group number. These addresses are
assigned in ascending numerical order.
Central address 123 456
ZONE–group 1-1 1-2 1-3 1-4 1-5 1-6
Indoor unit address 1-1 1-2 2-1 2-2 2-33-1
: Indoor unit address (UNIT No.)1 – 1
Indoor unit No.
Refrigerant circuit No. (R.C. address)
NOTE
07-115 SSHP_II 5/7/07 4:00 PM Page 90