Quadra-Fire QFP38-LP Indoor Fireplace User Manual


 
Quadra-Fire • QFP38 Series • 4061-300 Rev i • 9/09 63
L. Install Door Fronts
The doors should be lifted off the frame at the hinges to
make installation easier.
Make sure the templates have been removed, retain the
screws.
Fit the frame inside the unit opening and use the screws
from the facing template to attach the door frame to the
unit.
Install the doors by hanging on the hinges.
Install the door handles if necessary.
Glass
Latches
Figure 15.29 Fixed Glass Assembly
K. Fixed Glass Assembly
Removing Fixed Glass Assembly
WARNING! Risk of Asphyxiation! Handle xed glass
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
DO NOT strike, slam or scratch glass.
DO NOT operate replace with glass removed, cracked,
broken or scratched.
Replace as a complete assembly.
Removing Fixed Glass Assembly
Remove the fixed glass assembly by pulling and
realeasing the glass latches. There are two on top and
two on the bottom.
Pull forward on each latch and lift up while supporting
the glass assembly.
The glass assembly is heavy. Use caution while
removing.
Replacing Fixed Glass Assembly
Set the fixed glass assembly on the bottom glass
supports.
Push the glass assembly all the way to the rebox
assembly.
Support the glass assembly while pulling forward on
each latch and secure in place.
WARNING! Risk of Fire and Electric Shock! Use ONLY
Hearth & Home Technologies-approved optional acces-
sories with this appliance. Using non-listed accessories
could result in a safety hazard and will void the warranty.
IMPORTANT! This appliance should be run
three to four hours on low on the initial start-up.
Turn it off and let it cool completely. Remove and
clean the glass. Reinstall the glass and run the
appliance for an additional 12 hours. This will help
cure the products used in the paint and logs.