Filter
Top Products
Quadra-Fire • QFP38 Series • 4061-300 Rev i • 9/0958
Figure 15.6 Position Log #4061-170
E. Install Logs, Ember Bed
Align notches of ember bed with tabs on rear burner
Figure 15.7 Position Ember Bed #4061-171
• Position ember bed over the burner locating the notches
of the ember bed inside the tabs of the rear burner. See
Figure 15.7. Make sure the ember bed is not covering
any gas ports on the burner.
• Place a narrow band of small rockwool pieces on the
burner pan in front of the ember bed.
• Position the slots in the log over the tabs in front of the
rear burner. See Figure 15.8.
Rockwool behind tabs on burner pan
Figure 15.8 Position Log #4061-172
• Position the slots in the rear log over the locating tabs
at the rear of the hearth pan. See Figure 15.6.
NG
LP
• Your QFP38 log support/bracket is set at the factory
for natural gas or propane. Ensure the screws are in
the proper holes. See Figure 15.5. If position is not
correct, remove screw from each side and pull support
forward for NG, push back for LP. There is only a slight
adjustment.
Figure 15.5 Log Bracket is Pre-set for NG or LP
• Adjust log forward for NG and push back for LP. There
is only a slight adjustment.