Quadra-Fire QFP38-LP Indoor Fireplace User Manual


 
Quadra-Fire • QFP38 Series • 4061-300 Rev i • 9/09 57
A. Remove Fixed Glass Assembly
See Section 15.K.
B. Remove the Shipping Materials
Remove shipping materials from inside or underneath the
rebox.
C. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the rebox or underneath in the control cavity.
D. Install the Refractory
Remove the refractory retainer from each side of the
rebox.
Put the left side refractory in place and reinstall the left
side refractory retainer.
15
15
Appliance Setup
Refractory Retainer
Figure 15.1 Install Left Side Refractory
Install the lower back refractory.
Figure 15.2 Install Lower Back Refractory
Install the upper back refractory.
Figure 15.3 Install Upper Back Refractory
Install the right side refractory.
Figure 15.4 Install Right Side Refractory
Slide the back refractory slightly from side to side as
necessary to close up any gaps in the corners.
Install the right side refractory retainer.
Note: As you use the appliance, expansion and contraction
will cause minor cracking of the refractory. This is normal,
unavoidable, and will not affect the performance of the
appliance. If the cracks become large enough that the
metal behind the refractory is exposed or large pieces
fall out, the panels should be replaced.