Filter
Top Products
Quadra-Fire • QFP38 Series • 4061-300 Rev i • 9/09 61
H. Accent Lighting Set Up
• Remove the two screws (one on each side) holding the
dashboard in place.
• Unplug the two brown wires from the back of the ON/OFF
switch.
• Set the dashboard and two screws aside for later
reinstallation.
Screws
Figure 15.20 Remove Dashboard
• Turn off the control module and/or unplug light cord
(white) before moving on.
• Locate one of the two light boxes (one on each side
behind dashboard). See Figure 15.21.
Light Box
Rubber band
Figure 15.21 Light Box
• Clip and discard the rubber band holding the light box
in place.
Figure 15.22 Clip the Rubber Band
• Pull out the light box.
Pull light box out of housing
Figure 15.23 Pull Out Light Box
• Remove lightbulb from box, discard box.
• Plug bulb into socket as shown in Figure 15.24.
Figure 15.24 Plug Bulb into Socket
• Slide light assembly back into light housing.
Figure 15.25 Replace Light Assembly