Filter
Top Products
Quadra-Fire • QFP38 Series • 4061-300 Rev i • 9/09 55
Doors - Outside Surface Fit
Sheetrock/wall fi nishing material will have been installed
and the joints fi lled.
• Remove facing templates, retain screws for door
installation.
• Non-combustible facing material less than one inch thick
may be brought to the edge of the fi replace opening.
• Doors will be mounted over facing material.
• Door frame is slotted to allow the door to be mounted
up to one inch from the surface of the fi replace.
Doors - Recessed Fit
Sheetrock/wall fi nishing material will have been installed
and the joints fi lled.
• Facing material must be butted to the fl anges of the
facing templates.
• Remove templates - retain screws for door installation.
Template
Pieces
Figure 14.4 Facing Template
B. Facing Template Removal
There is a metal template on each side and across the
top of the door opening. See Figure 14.4.
• Side Templates
- Remove the screws from the sides of the door
opening and set aside.
- Remove and discard the template pieces.
• Top Template
- Loosen the screws across the top of the opening.
- Slide the top template out and discard.
- Tighten the screws.
Figure 14.3 Door Frame Flush to Bottom Edge of Fireplace