Filter
Top Products
Quadra-Fire • QFP38 Series • 4061-300 Rev i • 9/0912
J. Receiver
• The receiver is powered by four AA batteries.
• The receiver accepts commands via radio frequency from the transmitter to operate the appliance in accordance with
the system confi guration.
• The receiver three position slider switch can be set to one of three positions:
- ON (manual override)
- REMOTE (remote control)
- OFF
3 Positions Slider
PRG Key
12 PIN terminal
Figure 2.5 Receiver Body
K. Initializing the System for the First Time
Install the four AA batteries into the receiver battery bay. Note the polarity of the battery and insert into the battery bay as
indicated on the battery cover (+/-). Place the 3 position slider switch in the REMOTE postion. Using the end of a paper
clip, or other similar object, insert the end of the paper clip into the hole marked “PRG” on the receiver front cover. The
receiver will “beep” three times to indicate that it is ready to synchronize with a transmitter. Install the three AAA batteries
in the transmitter battery bay, located on the base of the transmitter. With the batteries already installed in the transmitter,
push the ON button. The receiver will “beep” four times to indicate the transmitter’s command is accepted and sets to the
particular code of that transmitter. The system is now initialized.