Filter
Top Products
Page 58
433-1390D
September 7, 2007
R
7100FP EPA Woodburning Fireplace
4
5
5
55
5
5
5
5
3
5
5
5
5
5
2
2
2
2
2
4
5
5
5
3
1
1
C. Brick Replacement
The fi rebox of your fi replace is lined with high quality
fi rebrick, which has exceptional insulating properties.
There is no need to use a grate; simply build a fi re
on the fi rebox fl oor. Do not operate the fi replace
without fi rebrick.
IMPORTANT: The bricks are very similar in size. Be
certain you have the proper brick in the correct location.
Measure the brick size for accuracy.
1. After the coals are completely cooled, remove
all old brick and ash from unit and vacuum out
fi rebox.
2. Remove the brick from the box and lay out to
diagram as shown in Figure 58.1.
3. Lay bottom bricks in unit.
4. Install rear bricks on the top of the bottom bricks.
Slide top of bricks under clip on back of fi rebox
wall and push bottom of brick back.
5. Install side bricks. Slide top of brick under clips
on side of fi rebox and push the bottom of the brick
until it is fl ush with the side of the unit.
Use Part 832-2370 when ordering individual brick. Pro-
vide brick dimension or copy this page, mark the desired
brick and take it to your authorized dealer.
Figure 58.1 Brick Pattern
5
5
5
5
5
5555
5
1
1
4
2
2
2
2
2
4
5
5
5
3
5
5
5
3
Left Side
Right Side
Back
Floor
Figure 58.2 Brick Pattern
1-1/4"
3-1/4"
9.0"
1
# Brick Size Qty. In Set
1 9” x 3-1/4” x 1-1/4” Angled (see drawing) 2
2 6-1/4” x 4-1/2” x 1-1/4” 5
3 9” x 2” x 1-1/4” 2
4 6-1/4” x 3-1/2” x 1-1/4” 2
5 9” x 4.5” x 1-1/4” 16