Filter
Top Products
Page 42
433-1390D
September 7, 2007
R
7100FP EPA Woodburning Fireplace
TOOLS NEEDED: Powered drill with #2 Phillips head bit; caulk-
ing gun.
1in. (25mm) OVERLAP
Metal strips 2 in. (51mm) under edge of
Fireplace and Hearth Extension and 2 in.
(51mm) on both side of fireplace opening.
Nail or screw metal strips in place.
Seal with
non-combustible
sealant
Top
Board
Bottom
Board
Side
Board
Side
Board
Apply bead of
Super Calstick to
edge here
1. Secure the fi replace to the fl oor or wall framing studs at
a minimum of two attachment points to prevent further
movement of the fi replace. The same holes and L brack-
ets that attached the fi replace to the pallet may be used
to secure the fi replace to the sub fl ooring by using a mini-
mum of two 1/4 in. x 2 in. lag bolts or equivalent.
Refer
to Figure 42.1 and install the two metal hearth strips at
this time.
E. Non-Combustible Facing Material Installation
Figure 42.1
Figure 42.2
Figure 42.3
Figure 42.4
Complete installation
NOTE: All boards are pre-drilled for your convenience.
Boards MUST be attached in the following order:
bottom, top, and then the two sides.
2. Attach the bottom board to the bottom of the outer fi re-
place can with enclosed screws, ensuring the board is
centered.
3. Center and attach the top board to the outer can and
framing members.
4. Using the Super Calstick, run a light bead (1/8 in. mini-
mum) on the butt edges of the top board.
See Figure
42.2.
5. Ensuring the top of the side pieces and the top board
align, attach the side pieces to the outer can and framing
members.
6. Use a wet or dry towel or a soft brush to remove any
dust or dirt from facing material. Apply a non-combustible
adhesive to attach tile, stone or other non-combustible fi n-
ishing materials per manufacturer’s instructions.
7. The non-combustible Super Calstick may be used for
sealing between the fi replace and the hearth extension.
Refer to Figure 42.3.
Risk of Fire.
• Follow these instructions exactly.
• Facing materials must be installed properly
to prevent fi re.
• No materials may be substituted
without authorization by Hearth & Home
Technologies.
WARNING