Filter
Top Products
Page 32
433-1390D
September 7, 2007
R
7100FP EPA Woodburning Fireplace
B. Baffl e Removal and Installation
1. Remove all ash from fi rebox, and extinguish all hot embers
before disposal into a metal container.
2. Remove the baffl e protection channel by turning it down
and pulling it out of the fi rebox. See Figure 32.1.
Figure 32.2 Removing Manifold Tube
Figure 32.3 Removing Baffl e (shown without ceramic blanket)
C. Door and Door Gasket
Periodically check the door gasket for proper seal. As the gasket
compresses or “seats” during use, it may become necessary to
adjust or tighten the door latch.
To Adjust or Tighten Door Latch
Remove spacing washers shown in Figure 32.4. At least one
spacing washer and the black washer must be left in place.
OR
Replace the gasket material. Wear or damage to the gasket
material can cause air leakage into the fi rebox resulting in
overfi ring and loss of effi ciency.
A replacement gasket is available from your dealer.
Figure 32.4 Door Handle Assembly
Latch Cam
Spacing Washers
Door Handle Shaft
Fiber Handle
Right Door
Locknut
Left Door
Black Washer
DO NOT REMOVE
Square
Key
Left Handle
Assembly is
stationary
Locking
Pin
Hinge Pins &
Washers
Figure 32.1 Removing Baffl e Protection Channel
3. Remove ceramic blanket from above the baffl e.
4. With a 3/16 in. Allen wrench, remove the front manifold
tube retainer bolt on the air channel under the end of
the front tube. See Figure 32.2.
NOTE: Soak the bolt with penetrating oil for at least 15
minutes before trying to remove it.
5. To remove manifold tube, slide the tube to one side
until one end is out of its hole. Then, while lifting that
end of the fi ber board baffl e, pull tube up over the air
channel and out of hole at the other end. It is only
necessary to remove the fi rst tube in order to remove
the baffl e.
6. Slide fi ber board baffl e forward to front of fi replace and
straight out through door. See Figure 32.3.
7. To install the fi ber board baffl e, repeat steps 2 through
4 in reverse. Be sure the fi ber board baffl e and ceramic
blanket are pushed back fully and the blanket is down
and fl at.