Filter
Top Products
57
Chapter 7: Programming
To display the current input names, values, and status, type show inputs after an ISACC
prompt:
ISACC>show inputs
INPUT NAME VALUE STATUS LOW LIMIT HIGH LIMIT MIN MAX
IN01 = "Input #1 " = Open OK
IN02 = "Input #2 " = Open OK
IN03 = "Input #3 " = Open OK
IN04 = "Input #4 " = Open OK
IN05 = "Input #5 " = Open OK
IN06 = "Input #6 " = Open OK
IN07 = "Input #7 " = Open OK
IN08 = "Input #8 " = Open OK
IN09 = "Input #9 " = Open OK
IN10 = "Input #10 " = Open OK
IN11 = "Input #11 " = Open OK
IN12 = "Input #12 " = Open OK
IN13 = "Input #13 " = Open OK
IN14 = "Input #14 " = Open OK
IN15 = "Input #15 " = Open OK
IN16 = "Input #16 " = Open OK
ITYPE
This command allows you to program the input type for each of the 16 inputs and assign a
descriptive name. NOTE: The input type programmed must correspond with the shunt
configuration on the ISACC circuit board. See Chapter 4: Inputs. The input types are:
00=Digital: Normally Closed 07=Analog: 10K F
01=Digital: Normally Open 08=Analog: 10K C
02=Digital: Pulse Count 09=Analog: Table 1
03=Analog: 4-20mA 10=Analog: Table 2
04=Analog: 0-5 Volts 11=Analog: Table 3
05=Analog: 2.8K F 12=Analog: Table 4
06=Analog: 2.8K C 13=User Defined
Input type 13 - User defined. The value for an input defined as type 13 is not received from a
physical input but is generated from a C program. See SET_INPUT, Chapter 8.
To display the current input type and name, type show itype after an ISACC prompt. You
may also display a specific itype by typing show itype followed by the number of the input.
ISACC>show itype
INPUT TYPE
IN01 is now Digital: N.O. Name = "Input #1 "
IN02 is now Digital: N.O. Name = "Input #2 "
IN03 is now Digital: N.O. Name = "Input #3 "
IN04 is now Digital: N.O. Name = "Input #4 "
IN05 is now Digital: N.O. Name = "Input #5 "
IN06 is now Digital: N.O. Name = "Input #6 "
IN07 is now Digital: N.O. Name = "Input #7 "
IN08 is now Digital: N.O. Name = "Input #8 "
IN09 is now Digital: N.O. Name = "Input #9 "
IN10 is now Digital: N.O. Name = "Input #10 "
IN11 is now Digital: N.O. Name = "Input #11 "
IN12 is now Digital: N.O. Name = "Input #12 "
IN13 is now Digital: N.O. Name = "Input #13 "