Filter
Top Products
29
Chapter 3: Communication Setup
To configure P10 for 2400 bps, the shunts must be ON ON OFF:
1
2
3
P10
ON OFF
Shunt configuration for 2400 bps
To configure P10 for 4800 bps, the shunts must be OFF OFF ON:
1
2
3
P10
ON OFF
Shunt configuration for 4800 bps
To configure P10 for 9600 bps, the shunts must be ON OFF ON:
1
2
3
P10
ON OFF
Shunt configuration for 9600 bps
NOTE: Again, do not change the configuration of the shunts for local communica-
tions unless you are absolutely positive that your terminal cannot communicate at
9600 bps.