Filter
Top Products
-49-
• A mail can be sent to a maximum of four addresses,
with or without attached picture file.
A mail contains: the camera name, time & date of
occurrence, cause of event, and the reference
addresses to the stored pictures as follows.
The number of stored alarm pictures: e.g., 472
URL of the picture: http//(Camera IP address)/
ALMxxxx_00.jpg
Notes:
•“xxxx” stands for the event number, and “00” for the
picture number.
• A picture numbered “00” will be automatically
attached to the mail.
• Enter “39” instead of “00” in the address bar if you
wish to view #40 picture.
• There may be cases where you cannot access the
images notified by the mail when new alarm activa-
tions took place after having sent the mail.
• The alarm picture number is updated during record-
ing.
• Alarm pictures and recording log are deleted when
the power is turned off.
• The Alarm List number is updated as alarm pictures
are to the set number.
■ Transferring Picture Files
• You need to set the Alarm FTP Transmission to ON
in the FTP Client menu.
• Pre- and post-alarm picture files can be sent to and
stored on a designated FTP server.
• A picture file attached to a mail can be sent to the
specified mail addresses.
Note: When many alarm events arise at the same time,
it may happen occasionally that a mail is sent with-
out an alarm picture attached.
■ Canceling Alarm Display
“Alarm” display in the upper center will disappear when
you do the following.
• Click the [Go to Main Menu] button after once the
Alarm List.
Or
• Click the [Go to Main Menu] button after opening
any of the setup menus.
■ VMD Setup
You can set up VMD (Video Motion Detector).
● Detection Area Setup
1. On the Setup Menu tab, click the [Camera] button.
The menu control buttons appear under the image
display area.
2. Click the [MENU ON] button.
** SET UP ** will be overlaid on the camera picture.