Filter
Top Products
8
W415-0788 / A / 09.22.09
2.5 CARE OF GLASS
5.1
DO NOT CLEAN GLASS WHEN HOT! DO NOT USE
ABRASIVE CLEANERS TO CLEAN GLASS.
Buff lightly with a clean dry soft cloth. Clean both sides
of the glass after the fi rst 10 hours of operation with a
recommended fi replace glass cleaner. Thereafter clean
as required. If the glass is not kept clean permanent
discoloration and / or blemishes may result.
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
!
WARNING
2.6 SHIPPING BRACKET
SHIPPING BRACKET REMOVAL
A. Remove the four screws holding the shipping bracket to the
bottom of the appliance.
B. Lift the appliance off the skid and set on a fl at surface.
C. Discard the screws, brackets and skid.
GLASS DOOR REMOVAL
A. Lift the top casting off.
B. Open the valve control cover. Pull the latch handles forward to
release. The door may now be safely removed by swinging the
bottom out and lifting it off.
!
WARNING
THE TOP CASTING IS NOT FASTENED TO THE STOVE ASSEMBLY. IT SIMPLY SITS ON THE STOVE
AS A LID. FOR SHIPPING PURPOSES IT IS HELD IN PLACE BY PLASTIC STRAPPING. ONCE THE
STRAPPING IS CUT, THE TOP SHOULD BE LIFTED OFF CAREFULLY AND STORED IN A SAFE PLACE
TO AVOID DAMAGE WHILE COMPLETING THE INSTALLATION OF THE STOVE. TO AVOID THE APPLI-
ANCE BEING DAMAGED DURING SHIPPING, A SHIPPING BRACKET HAS BEEN USED AND MUST BE
UNBOLTED BEFORE THE APPLIANCE CAN BE INSTALLED.
SHIPPING BRACKET
FIGURE 2.6a
LATCH
FIGURE 2.6b