Filter
Top Products
35
W415-0788 / A / 09.22.09
6.4 LOG PLACEMENT
1
4
2
3
5
Blocked burner ports can cause an incorrect fl ame pattern, carbon deposits and delayed ignition. Phazer
tm
logs
glow when exposed to direct fl ame and provide a unique and realistic glowing effect. Use only certifi ed phazer
tm
logs available from your Napoleon® dealer.
Place log #1 onto the burner, centering it onto the
burner tray and pushing it as close to the rear wall of
the fi rebox as possible. Move logs # 2 and 3 into po-
sition, lining up the studs located on the burner with
the holes on the bottom of the logs. Sit the notch at
the bottom of log #4 against the left outermost grate
post and position the top of the log into the pocket
provided on the rear log (#1).
The notch in log #5 should be pressed down onto
the skewering pin located at the end of the grate as
shown to prevent it from rocking.
6.3 GLASS / DOOR REPLACEMENT
6.3.1 Place the door frame face down careful not to scratch the paint.
6.3.2 Center the gasketed glass inside the door frame with the thick
side of the gasket facing up.
6.3.3 Bend the glass retainers located along the edge of the door
frame over the gasket holding the glass in place. Be careful not
to break the glass.
GLASS
GASKET
DOOR
FRAME
GLASS
RETAINER
FIGURE 6.3
!
WARNING
DO NOT USE SUBSTITUTE MATERIALS.
GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.
CARE MUST BE TAKEN WHEN REMOVING AND DISPOSING OF ANY BROKEN DOOR GLASS OR
DAMAGED COMPONENTS. BE SURE TO VACUUM UP ANY BROKEN GLASS FROM INSIDE THE
APPLIANCE BEFORE OPERATION.
DO NOT STRIKE, SLAM OR SCRATCH GLASS. DO NOT OPERATE APPLIANCE WITH GLASS
REMOVED, CRACKED, BROKEN OR SCRATCHED.
56.1