Filter
Top Products
36
W415-0788 / A / 09.22.09
6
7
Position the notch located in log #6 against the grate
post.
Place the bottom of log #7 against the right outermost
grate post and the top into the pocket provided on the
center log (#6). Bend up the tab in the log support to
cradle log #7. Tear the glowing embers into pieces
and place onto the front of the burner. Care should
be taken to shred the embers into thin, small irregular
pieces as only the exposed edges of the fi bre hairs
will glow when exposed to direct fl ame; however care
should be taken to not block the burner ports. Blocked
ports can cause an incorrect fl ame pattern, carbon
deposits and delayed ignition.
Log colours may vary. During the initial use of the
appliance, the colours will become more uniform as
colour pigments burn in during the heat activated cur-
ing process.
POSITIONING THE LOGS IMPROPERLY WILL
CAUSE FLAME IMPINGEMENT AND
CARBONING.
6.5 LOGO PLACEMENT
Remove the backing of the logo supplied and centre over the logo installation holes, as indicated.
FIGURE 6.5