Filter
Top Products
4
1.2 Required Operating Environment
This manual refers to Windows
®
2000 as Windows 2000, and Windows
®
XP as Windows XP.
Trademarks
MS, Microsoft, Microsoft logo, and Windows are registered trademarks and trade names of Microsoft
Corporation.
Each company may use as registered trademarks and trade names the product names used in this
manual.
1.2.1 Hardware Requirements
The computer must be IBM compatible on DOS/V and capable of satisfying the following requirements.
- OS .................... Windows2000 or WindowsXP (Recommended English version *1)
- CPU .................... PentiumIII 500 MHz (Recommended 1GHz or more)
- RAM .................... Minimum 128 MB (Recommended 256MB or more)
- HDD .................... Available space 5 GB or more *2
- LCD .................... Display resolution:XGA(1024x768) or more
Unit should be equipped with a pointing device, such as a mouse pointer or track ball.
1.2.2 Required Materials
The following materials are needed for operating the Maintenance Tools :
(1) In case of routing via MN converter
MN Converter (CMS-MNF), Personal Computer, RS-232 (cross), and modem in the case of remote
connection, are required. RS-232 C is to be straight cable in this case.
For detail, please see Installation Manual-annexing of MN Converter (CMS-MNF).
(2) In case of routing via G-50
G-50, personal computer, LAN cable (Straight) and HUB.
A dial-up router is required for remote communication. For the dial-up router to be used, employ that
allowing data communication by receiving external telephone transmission.
*1 About OS
Fundamentally, it corresponds to OS of each country. However, separators of time and date differ in
each language. This separator may affect a maintenance tool.
It recommends using it by English OS and Regional options setup, changing into English area form.
Or it recommends using it, changing date separator into [/] and time separator into [:].
*2 About Hard Disk Space
The hard disk space recommended above is only the amount required for installing the maintenance
application. Additional space will be required if the operating data is also to be stored on the hard disk.
A
ccordingly, there may not be enough memory to store operating data if the maintenance system is
installed in a computer with limited hard disk memory.
* NOTE
TG-2000A and Maintenance Tool cannot operate with the same personal computer.