Filter
Top Products
24
3.2 Function Chart
Connecting Information ----------------------- [Refer to 3.6]
This allows monitoring of the indoor units connected to the outdoor unit and of the interlock units and the
operation group SC connected to indoor units.
Operation Monitor ------------------------------- [Refer to 3.7]
This allows monitoring of the operating condition of the unit and operating data. The operation data
obtained will be shown in the form of a graph.
Utilizing the mail communication mode in addition, the operation monitoring data collected by G-50A can
periodically be transmitted to remote mail servers, and it can be referred as the off-line data later.
*The Mail communication mode can not be used with MN Converter connected.
Malfunction Log ---------------------------------- [Refer to 3.8]
This allows monitoring of the ten most recent errors of the unit.
Optional Setting ---------------------------------- [Refer to 3.9]
This allows monitoring of self-diagnosis function, operation control and pre-error data monitoring.
This also allows to monitor the response to any M-NET command transmitted to the unit. Time setting.
Operation Control -------------------------------- [Refer to 3.10]
This allows the same operation as with the remote controller.
3.3 Address Search Method
3.3.1 Address Search Method Selection
(1) Start the M-NET Maintenance Tools and the Select The Address Searching Method Screen will
appear after the Title Screen.
(2) Click on either or to select the
address search method.
* Automatic Search
The Maintenance Tools automatically searches for
and displays information about units connected to
the M-Net transmission line.
* Manual Search
The user optionally searches for the units connect to the
M-Net transmission line.