Filter
Top Products
13
1.4.3 Starting the On-Line Monitor(G-50 connection)
* To use the maintenance tool via G-50 (Network), license registration for the G-50 to be used is necessary.
Purchasing the license No. for each G-50 to be used, conduct the license registration through the Web
browser (http://[IP address of the G-50A]/ administrator.html). After selecting "Maintenance tool" of the
optional function on the Web Browser Screen displayed, enter the purchased license No..
For the detail of the license registration, see Chapter 4 [Registering a License for Optional Functions] of
Central Controller Model: G-50A Web Browser Operation Manual (For manager).
* To use the maintenance tool via G-50 (Only for LAN mode and Dialup connection mode), please check a
setup of Internet Connection Firewall of PC. If the FIREWALL function is used, communication will be
normally impossible with G-50A, and normal data will not be displayed.
For detail, please refer to [6. How to change setting of Firewall] on Page 57.
In the case of permanently installing an anti-virus software and always started under this environment, the
fire wall function of this software may be activated sometimes. In such case, The normal communication with
G-50 will be hindered not displaying data normally. When operating Maintenance Tool, finish the anti-virus
software once or remove the fire wall function.
1.4.3.1 In case for local connection
In the case when on line monitoring is applied to air conditioning system via G-50 by connecting the
maintenance tool to LAN locally.
(1) Clicking "G-50(Network)" on the selection screen of
Monitor mode selects "Local connection" simultaneously.
Last click " ."
(2) Next IP address input screen is displayed. Here,input IP
address of G-50A connected to the air conditioning
system of which operating information is desired to
monitor, and click on .
Request
It is required to set to the IP address in the same system with
G-50 to be connected to Maintenance Tool PC from
[Control Panel].