Filter
Top Products
45
(2) Automatic monitoring
To automatically monitor the contact status of indoor
units of No.1 ~ 50 repeatedly,
select the [Auto monitor] mode.
a) Click the [Auto monitor] button on the mode
selection section.
The contact status of indoor units of No.1 ~ 50 will
automatically be monitored, and this operation will
be repeated.
The display for [Attribute], [Indoor unit contact
mode], [Input contact (monitor)] and [Output
contact (monitor/operation)] are identical to that in
the manual monitoring.
* In the case to terminate the auto mode, selecting other mode will stop the monitoring.
3.11.3 Operation of output contact
(1) Contact operation
To operate for the ON/OFF selection of the output
contact of indoor units, select the [Operation contact]
mode.
a) Click the [Operation contact] button on the mode
selection section.
b) Click the [Output contact (ON/OFF)] button of the
unit for which the ON/OFF of the output contact
is desired to be selected for change.
*The state where the button is being depressed
(with bold letter)
displays the present output status.
[Option] function
Affixing a check mark to [It checks before
transmission] displays the warning screen as
shown right before transmitting actual transmission
command at the operation of output contact.
To continue the transmission, click [Yes].
When a check mark is not affixed, the transmission
command will be transmitted at the clicking of the
[Output contact (ON/OFF)] button simultaneously.
3.11.4 Termination of this function
(1) Clicking the [Close] button will close this screen and return to the main screen display.