Filter
Top Products
OPERATING PROCEDURE
PHOTOS
4. Removing the LEV coil (LEV-A–E)
(1) Remove the controller cover. (See Photo 1)
(2) Remove the under cover. (See Photo 1)
(3) Remove 4 separator fixing screws (4 o 10) in the side of
the branch box. (See Photo 4)
(4) Tilt the separator to the board side. (See Photo 4)
(5) Loosen the side clamps of the board and disconnect the
connectors on the board.
(6) Pull out the lead wire through the U-shaped hole.
(See Photo 3)
(7) Cut the band that fixes the lead wire to pull out the LEV
coil (LEV-A –E). (See Photo 5)
Photo 4
Separator fixing screws
Separator
Photo 5
Separator LEV coil
Band
HEAD OFFICE : TOKYO BLDG., 2-7-3, MARUNOUCHI, CHIYODA-KU, TOKYO100-8310, JAPAN
cCopyright 2010 MITSUBISHI ELECTRIC ENGINEERING CO., LTD.
Distributed in Jun. 2010 No. OCH468 REVISED EDITION-A PDF 5
Distributed in Feb. 2010 No. OCH468 PDF 5
Made in Japan
New publication, effective Jun. 2010
Specifications subject to change without notice