Filter
Top Products
78
8-9. SELECTING FUNCTIONS USING THE REMOTE CONTROLLER
Each function can be set according to necessity using the remote controller. The setting of function for each unit can only be
done by the remote controller. Select function available from the table 1.
(1) Functions available when setting the unit number to 00
W1 The functions table below are available only when P-series indoor unit and the wired remote controller is used.
W2 After the power supply returns, the indoor unit does not operate for 3 minutes (Some kind of indoor units operate for
30 seconds, after that, it stops for 3 minutes).
Above operation is normal.
<Table 1> Function selections
Meaning of "Function setting"
Mode02:indoor temperature detecting
No
Indoor temperature(ta)=
No.1
Average data of the
sensor on all the
indoor units
Initial
setting
ta=(A+B)/2 ta=(A+B)/2 ta=A ta=A
No.2
The data of the sensor
on the indoor unit that
is connected
with remote controller
ta=A ta=B ta=A ta=A
No.3
The data of the sensor
on main remote
controller
ta=C ta=C ta=C ta=C
OUTDOOR
INDOOR
REMOTE
(MAIN)
REMOTE
(SUB)
INDOOR
OUTDOOR
INDOOR
REMOTE
(MAIN)
REMOTE
(SUB)
OUTDOOR
INDOOR
REMOTE
(MAIN)
OUTDOOR
INDOOR
REMOTE
(MAIN)
REMOTE
(SUB)
INDOOR
Function
Settings
Mode No.
Setting No.
: Initial setting
(when sent from the factory)
Remarks
Power failure
automatic recovery
Indoor temperature
detecting
LOSSNAY
connectivity
Power supply
voltage
Frost prevention
temperature
Humidifier control
OFF
ON +2
Average data from each indoor unit
Data from the indoor unit with remote controller
Data from main remote controller
Not supported
Supported
(Indoor unit does not intake outdoor air through LOSSNAY
)
Supported
(Indoor unit intakes outdoor air through LOSSNAY)
230V
208V
2 [36°F](Normal)
3 [37°F]
When the compressor operates, the humidifier also operates.
When the fan operates, the humidifier also operates.
1
2
1
2
3
1
2
3
1
2
1
2
1
2
01
02
03
04
15
16
The setting is
applied to all
the units in the
same
refrigerant
system.