Filter
Top Products
24 Finalizing the Installation (for qualified installers only)
Travis Industries 100-01159 4040621
Log Installation
! Make sure the gas control valve is “OFF” and the heater is cool prior to conducting service.
! Failure to position the parts in accordance with these diagrams or failure to use only parts specifically
approved with this appliance may result in property damage or personal injury.
NOTE: The burner must be correctly positioned. Grasp the burner, lift it up,
position the gas inlet tube over the burner tube, and slide the
burner all the way down (see page 35 for details).
Place the rear log so the pins on the
burner insert into the holes in the log.
Place the front left log so the
pins on the burner insert into
the holes in the log.
Burner
Place the front right log so
the pins on the burner insert
into the holes in the log.
Place the left twig so the pin
on the rear log inserts into
the hole in the twig.
Place the right twig so the pin
on the rear log inserts into
the hole in the twig.
The installed log set
should look like this.