Filter
Top Products
System and Control Options
35
7.7 Setup System - Setup System Info
The Setup System Info options allow users to:
• Change Password—used for access to system setup functions
• Set Date & Time/Automatic Daylight Saving Time—used to set the AC4’s date and time and
to enable automatic time change for Daylight Saving Time
• Setup Site ID—the AC4’s location to differentiate among sites if more than one AC4 is in use
• Backup and Upload Configuration File (Service Terminal Interface only)—permits the
user to copy the AC4’s configuration settings and to upload the file to the AC4
• Factory Defaults—returns the AC4 to its factory settings
• Perform Firmware Update (Service Terminal Interface only)—changes the AC4’s firmware
to newest version
To change any Setup System Info features:
Log In and Choose Setup System
• From the Main Menu, use the arrows
↑↓ to choose System and
Control, then press Enter ↵ (see 7.1 - Login for help).
• Enter your password at the Login screen.
• From the System and Control Menu, use the arrows
↑↓ to choose
Setup System, then press Enter ↵.
Select Setup System Info
• From the Setup System Menu, shown at right, use the arrows
↑↓
to
choose Setup System Info and press Enter ↵.
• Use the following steps to access any of the Setup System Info options.
7.7.1 Change Password
A password is required to access the AC4’s system and control options,
as described in 7.1 - Login. The password consists of four characters
(see Table 12 for valid characters). The default password is AAAA.
Change the Password
To change the password:
• From the Setup System Info Menu, use the arrows
↑↓ to choose
Change Password, then press Enter ↵.
• To change your password:
• Use the arrows
↑↓ to choose a character.
• Press Enter ↵ to advance to the next character position.
• When finished, press Enter ↵ again.
Reset Password to the Factory Default (“AAAA”)
To reset the password to the factory default of AAAA:
• Locate DIP switch 1 on the unit’s circuit board (see 1.6 - Controller Board Overview) and move
all switches to the OFF position (down).
• Move the second switch to the ON position, then to the OFF position.
• Move the seventh switch to the ON position, then to the OFF position.
• Move the eighth switch to the ON position, then to the OFF position.
The password should now be AAAA.
Setup System Menu
SETUP INPUTS
SETUP COMMON ALARM
SETUP ZONES
↑↓=NEXT ↵=SELECT
SETUP OUTPUTS
> SETUP SYSTEM INFO
SETUP OPERATION
Setup System Info Menu
SETUP SYSTEM INFO
> CHANGE PASSWORD
SET DATE & TIME
↑↓=NEXT ↵=SELECT
SETUP SITE ID
FACTORY DEFAULTS
Change Password
CHANGE PASSWORD
AAAA
↑↓=SELECT ↵=NEXT/END