Filter
Top Products
Removal and replacement procedures 106
4. Using an Allen wrench, insert and tighten one of the original Allen nuts and bolts into the remaining
screw hole. Compress completely.
5. One by one, replace the three 40-mm Allen nuts and bolts with the original Allen nuts and bolts, until
the brackets are firmly compressed around the water inlet hose.
6. Using a pipe wrench, reconnect the water inlet hose to the supply hose and tighten the water inlet
coupling.
7. Restore water flow to the MCS unit ("Restoring water flow" on page 112).
8. Complete the operation checklist (on page 111).