Heatiator ECO-WINS18 Indoor Fireplace User Manual


 
37Heatilator • ECO-WINS18 • 7065-132B • August 29 2011
Thefollowingmodicationsoffactory-builtreplaces are
permissible:
• Thereplacemustnot bealtered. Cuttingany sheet
metalpartsofthereplaceinwhichthereplaceinsertis
tobeinstalledisprohibitedperANSIZ21.88exceptthat
thedampermayberemovedtoaccommodateadirect-
connectstarterpipeorchimneyliner,
• Externaltrimpieceswhichdonotaffecttheoperation
ofthereplacemayberemovedprovidingtheycanbe
storedonor withinthereplaceforreassembly ifthe
insertisremoved.
• Thepermanentmetal warninglabelprovidedinthe
componentpackmust beattachedtothebackof the
replace,withscrewsornails,statingthatthereplace
mayhavebeenaltered toaccommodate theinsert,
andmustbereturnedtooriginalconditionforuseasa
conventionalreplace.Figure 38.2.
• Manufacturerdesignedadjustablesupportkit canbe
orderedfromyourdealer.
• Finalapprovalofthisinstallationtypeiscontingentupon
theauthorityhavingjurisdiction.
Damper SmokeShelforBafe
EmberCatches FireGrate
ViewingScreen/Curtain Doors
Thefollowingpartsmayberemoved:
LINER CONNECTOR
FLUE
GAS
DIRECTION
CRIMPED
END
TOWARDS
STOVE
Figure 38.1
H. Altering the Fireplace
G. Securing Chimney Components
All joints shouldbe secured with 3 sheetmetal screws or
rivetsperpipemanufacturersinstructions.Thesectionsmust
beattachedtotheinsertandtoeachotherwiththecrimped
(male)endpointingtowardtheinsert.Figure 38.1.
250-2061
WARNING
THIS FIREPLACE MAY HAVE BEEN ALTERED
TO ACCOMMODATE AN INSERT. IT MUST BE
RETURNED TO ITS ORIGINAL CONDITION
BEFORE USE AS A SOLID FUEL BURNING
FIREPLACE.
250-2061
Heath & Home Technologies
250-2061
5.5 in. width x 2 in. height
NON. ANOD. ALUM BLACK LETTERS ON SILVER
with 1/8 in. holes on both sides.
Black letters
Figure 38.2
WARNING! Risk of Asphyxiation!
• DONOTCONNECTTHISAPPLIANCETO
ACHIMNEYFLUESERVICINGANOTHER
APPLIANCEORTOANYAIRDISTRIBUTION
DUCTORSYSTEM.
Thismayallowuegasestoenterthehouse.
I. Factory-Built Sold Fuel Fireplace
Apermitmayberequiredforinstallations,nalapprovalis
contingentoftheauthorityhavinglocaljurisdiction.Consult
insurancecarrier,localbuilding,reofcialsorauthorities
having jurisdiction about restrictions, installation inspec-
tion,andpermits.
Inspecttheexistingreplaceandchimneyforanydamage
orawssuchasburnouts,metalorrefectorywarping.
InspectiontoaminimumofNFPA211LevelIIisrecom-
mended.Allrepairsmustbemadepriortoinstallingan
insert. Thereplacemust bestructurallysound andbe
abletosupporttheweightofthesolid-fuelinsert
Thefactory-builtchimneymustbelistedperUL127orULC
610-M87forallinstallations.Installthermalprotectionper
thisappliancelistingrequirements.
A full height 6 inch diameter stainless steel full height
listed chimney liner must be installed meeting type HT
(2100°F) requirements per UL 1777 (USA) or ULC S635
with “0” clearance to masonry (Canada). The full liner
must be attached to the insert ue collar and to the top
of the existing chimney.
Theuelinertopsupportattachmentmustnotreducethe
airowfortheexistingair-cooledchimney system.Re-
installoriginalfactory-builtchimneycaponly.(SeeSec-
tionF.,PrefabricatedMetalChimney)
Topreventroomairpassagetothechimneycavityofthe
replace,sealeitherthedamperareaaroundthechimney
linerortheinsertsurround.Circulatingairchamber(i.e.in
asteelreplacelinerormetalhearthcirculator)maynot
beblocked.Theairowwithinandaroundthereplace
shallnotbealtered,blockedbytheinstallationoftheinsert.
(i.e.nolouversorcoolingairinletoroutletportsmaybe
blockedbytheinsertortheinsertsurround.
See“H.AlteringtheFireplace”formodicationsallowedfor
factory-builtreplaces.