Filter
Top Products
6
Pellets or Corn/Pellet Mixture Only 3-90-775 Save These Instructions
Consideration must be given to safety, convenience,
trafc ow, and the fact that the appliance will need to
be vented to the outside.
It is a good idea to plan your instal-
lation on paper. Use exact measurements for clear-
ances and oor protection, before actually beginning
the installation.
Maintain specied vent clearance to combustible
requirements listed by the vent manufacturers instruc-
tions and all appliance clearances as listed in this
manual.
Check with your local building code agency before
you begin your installation. Local codes may su-
persede the test laboratories specications. Always
obtain any required permit(s) so that insurance pro-
tection benets cannot be unexpectedly cancelled. If
any assistance is required during installation, please
contact your dealer.
We recommend that a qualied building inspector and
your insurance company representative review your
plans before and after the installation.
The room sensor's location will have some effect on
the appliance's operation. When the sensor is located
close to the appliance, it may require a higher set-
ting to keep the rest of the house comfortable. If the
sensor is located in an adjacent room, or farther away
from the stove, you will notice higher temperatures
near the appliance.
• Do NOT connect this unit to a chimney ue
servicing another appliance.
• Do NOT connect to any forced air distribution
duct or system.
Maintain the designated clearances to combustibles.
Insulation must not touch the chimney. You must
maintain the designated air space around the chim-
ney. This space around a chimney is necessary to
allow natural heat removal from the area. Insulation
in this space will cause a heat buildup, which may
ignite wood framing.
To provide reasonable re safety, the following should
be given serious consideration:
1. Install at least one smoke detector on each oor
of your home. Detectors should be located away
from the heating appliance and close to sleeping
areas. Follow the smoke detector manufacturer's
placement and installation instructions, and be
sure to maintain regularly.
2. A conveniently located Class A re extinguisher
to contend with small res resulting from burning
embers.
3. A practiced evacuation plan, consisting of at least
two escape routes.
4. A plan to deal with a hopper re as follows:
In the event of a hopper re:
a. Turn appliance to "OFF".
b.
c. Notify Fire Department.
d. Do NOT pour water in the hopper.
e. pull the plug or otherwise disconnect the
power supply to kill a re.
Fire Hazard
• Do not operate appliance before
reading and understanding the
operating instructions.
• Failure to operate properly may
cause a house re.