Filter
Top Products
33
Save These Instructions 3-90-775 Pellets or Corn/Pellet Mixture Only
As needed / Weekly
User
Whenever the view of the re is obstructed, or weekly,
clean the glass using a soft cloth dampened with stan-
dard household glass cleaner.
Inspect the glass and sealing gasket. Replace gasket
as needed. Do not operate the stove with a broken
glass. Replacement glass, which is ceramic glass,
should be obtained through your Harman dealer.
To replace a broken glass; rst be sure to carefully
remove the broken glass and any remaining shards or
pieces. With the door laying on a at surface, lay the
gasketted glass panel onto the door and be sure it is
properly tted into the channel. Lay the glass retainer
clips in place near each corner, and secure them
using the 3/8" screws. Be sure to tighten each screw
equally so you don't create a pressure point on the
glass.
Handle glass with care.
• Avoid striking, scratching, or slamming glass.
• Do NOT Clean Glass When Hot.
• Do NOT use abrasive cleaners.
• Inspect gasket, replace if necessary.
Retainers and screws
Glass
Adhesive gasket
Door Frame
Yearly or more frequently depending
on ash build-up.
Service Technician / Chimney Sweep
The products of combustion will contain small
particles of y ash. The y ash will collect in the
exhaust venting system and restrict the ow of
exhaust gases.
During periods of incomplete combustion, which may
occur during start-up, shut down, or when operated
incorrectly, the y ash may actually lead to soot
formation in the venting system.
The venting system will need to be cleaned at least
once per year, or more often depending on the quality
of the fuel being used. Horizontal sections of vent
pipe are especially prone to soot formation, as ash will
accumulate more quickly.