Filter
Top Products
Problem What To Do
Remote Control hasless , Relocate Remote Control inside car.
than 2S'operating range • Ensure Remote Control is pointing toward garage door when pressing Control Button.
, Replace Remote Control Battery _'I/ER_'/ID_ type"A23." (See page 22).
Reposition Opener Antenna Wire.
Do Not attempt to retune Remote Controls or Receiver.
Opener works from Wall • Program code for each Remote Control into Receiver memory (See Programming the Remote
Control, but not from Control on page 22.
Remote Control , Replace Remote Control Battery _B/ERBID_ type"A23." (See page 22).
Check Safe-T-Beam®System for beam obstruction or misalignment of Lenses.
Check Safe-T-Beam®System for any diagnostic codes. If present, troubleshoot as detailed in
Safe-T-Beam® System Self-Diagnostic Troubleshooting Chart (See page 26).
Noisy operation • Ensure all fasteners are tightened.
Check that the garage door and Opener are in good repair, properly lubricated, and properly
balanced. (See Maintenance page 25).
W_:n_//_s. If you suspect a problem with garage door hardware or springs, contact a Genie
Factory Authorized Dealer for service, or contact Customer Service at 1-800-35-GENIE.
Safe-T-Beam® System , If an operational problem exists, Opener will not run closed.
Check Safe-T-Beam®System for beam obstruction or misalignment of Lenses.
®
• CheckSafe-T-Beam Systemforany diagnostic codes. Ifpresent, troubleshootas detailed in Safe-T-Beam®
SystemSelf-DiagnosticTroubleshooting Chart (Seepage 26).
Door closes,and Opener , Check position of Wall ConsoleVacation Lock Switch. It must be in UNLOCKEDposition for Opener to
shuts down open door.
WARNING Opening Cover May Cause Electric Shock I
WALLCONTROL
_b- lal
&
k-
CONTROLLER BOARD
I OPEN LIMIT
- -_
-@
WHITE (_)
WHITE
@
i
i
i
I '
1
1
1
i
I CLOSE LIMIT
PRIMARYGROUND
MOTOR DRIVE BOARD
----111t
19k
13f
GREEN
BLUE
BLACK
WHITE
WHITE
_T LINE
_AX.
GREEN
_L
SECONDARYGROUND