Filter
Top Products
GarageDoorsareheavyobjectsthatmovewiththehelpofsprings
underhightensionandelectricopeningequipment.Sincemoving
objects,springsundertension,andelectricopeningequipment
maycauseinjuries,yoursafetyandthesafetyofothersdependon
youreadingandunderstandingtheinformationinthismanual.
Ifyouhavegaragedoorrelatedquestionsordonotunderstandthe
informationpresented,callyournearestGenieFactoryAuthorized
Dealerlistedatwww.geniecompany.com,orcustomerServiceat
1-800-35-GENIE..
MOVINGDOOR
ELECTRICALSHOCK
HIGHSPRINGTENSION
WARNING:
Can Cause Serious
Injury or Death
WARNING:
Can Cause Serious
Injury or Death
WARNING:
Can Cause Serious
Injury or Death
o Keep people clear of opening while door is moving.
o Do Not allow children to play with the door operator.
o Do Not operate a door thatjams or one that has a broken spring.
oTurn off power before removing operator cover.
oWhen replacing cover, make sure wires are not pinched or near
moving parts.
oOperator must be properly grounded.
oDo Not try to remove, repair or adjust springs or anythinqto
which door sprinq parts are tastened, such as, woodl blocks,
steel brackets, cables or other like items.
oRepairs and adjustments must be made by a trained service
person using proper tools and instructions.
.& WARNING;
TO REDUCE THE RISK OF SEVERE INJURY OR DEATH:
1 READAND FOLLOW ALL SAFETY,INSTALLATIONAND
OPERATIONINSTRUCTIONS.If you have any
questions or do not understand an instruction, call
your service representative.
2 Do Not install operator on an improperly balanced
door. An improperly balanced door could cause
severe injury. Repairs and adjustments to cables,
spring assembly, and other hardware must be made
by a trained service person using proper tools and
instructions.
3 Remove all ropes, and disable all locks connected to
the door before installing operator.
4 Install door operator 7 feet or more above the floor.
Mount the emergency release knob 6 feet above
the floor.
5 Do Not connect the operator to the source of power
until instructed to do so.
6 Locatethe control button:
• Within sight of door.
• At a minimum height of 5 feet, so small children
cannot reach it.
• Away from all moving parts of the door.
7 Install the entrapment WARNING label next to the
wall button or console. Install the emergency release
tag on, or next to, the emergency release
8 The operator must reverse when the door contacts a
1-1/2 inch high object on the floor at the center of
the doorway.This is about the size ofa 2"x 4" board
laid flat.
Safe-T-Beam ® (STB) Non-Contact Reversing System
Places an invisible beam across door opening, that reverses
the door during down travel to the fully open position if
anything passes through beam.
Safe-T-Reverse ® Contact Reversing System
Automatically stops and reverses a closing door within 2
seconds of contact with an object.
Safe-T-Stop ® Timed Reversed System
Automatically opens a closing door, if door does not close
within 30 seconds.
Force Guard ® Control
Used to set the force required for opening and closing
door. For maximum safety, set the minimum force required
to fully open and close door.
Automatic Lighting System
Two light bulbs up to 60 Watts max. each, are used for safer
entries and exits.The light turns on when door isactivated
and automatically turns off 4.5 minutes later.
Manual Emergency Release
Allows the garage door to be opened or closed manually
for emergencies or maintenance.