Filter
Top Products
Installation and Wiring Page 2-1
2
TS-TPI Installation and Wiring Guide
2 TS-TPI INSTALLATION & WIRING
Overview
The TS-TPI Turbine Pump Interface is a communication device that allows the INCON TS-1001,
TS-2001 Automatic Tank Gauge (ATG) or other devices to communicate with the turbine pump
controllers (TPC). The TS-TPI is available as a stand alone unit, which requires its own input
power, and as an integrated factory installed option in the TS-LS300 AutoLearn Line Leak Detec-
tor. The TS-TPI allows the ATG or other device to receive pump status information and, depend-
ing on the type of TPC, controls the pump.
In this chapter a brief description of each application is presented as well as the wiring of each
component for the particular application. Please contact Franklin Fueling System Technical
Support, (800)984-6266 if the TS-TPI is to be used in any other application.
Specific details of installation and the general programming instructions for the ATG is found in
the Tank Sentinel Installation Guide (part number 000-1050). Specific programming instructions
concerning the TS-TPI with the ATG will be covered in this Guide.
Look for your specific application on the following pages. Wire the components according to the
wire diagram and then go to the next chapter “Tank Sentinel/TS-TPI Interface” for information on
the features of the TS-TPI. The rest of the chapters provide instruction for programming the ATG
to take full advantage of the TS-TPI.
Here are the application options covered in this guide:
● TS-ATG with TS-TPI and TS-LS300 AutoLearn Console
● TS-ATG with TS-TPI, TS-LS300 AutoLearn Console and TPCs
● TS-ATG with TS-TPI and two TS-LS300 AutoLearn Consoles
● TS-ATG with TS-TPI, two TS-LS300 AutoLearn Consoles and TPCs
● TS-ATG with Stand alone TS-TPI and TPCs
● Stand alone TS-TPI with TPCs
ELECTRICAL DANGER
Verify that no voltage exists before working-on, or wiring-to
circuits described in this manual, otherwise lethal electrical-shock-hazards could exist, which
may cause injury or death. Note: circuit breaker contact(s) can fail to open even when the
circuit breaker lever indicates off.
ELECTRICAL DANGER
BEFORE performing any installation or service lock-out and tag
all electrical power sources to the submersible pump(s), pump controllers, and dispensers
and relieve fuel-line pressure. Electronic line leak detectors start submersible pumps automatically
to run leak-tests. Automatic pump starts occur between periods of product dispensing when there is
no product being dispensed.