Filter
Top Products
SAFETY Page 1-1
1
TS-TPI Installation and Wiring Guide
1 SAFETY
Graphic Symbol Conventions
Through out this User Guide these symbols will highlight information for your safety and the
proper functioning of this equipment. Read carefully the steps in this guide and pay special
attention to the steps where you see these symbols.
Important information, tips, and hints are highlighted by the note graphic.
CAUTION
messages are highlighted by the CAUTION graphic and contain instructions
that should be followed to avoid faulty equipment operation, or environmental hazards, or
personnel injury!
WARNING
messages are highlighted by the WARNING graphic and contain instructions
that must be followed to avoid faulty equipment operation, or explosion or shock hazards. If
ignored, severe injury or death may result!
DANGER
messages are highlighted by the DANGER graphic and contain instructions that
must be followed to avoid an explosion or electrical shock hazard. If ignored, severe injury or
death will result!
ELECTRICAL DANGER
messages are highlighted by the ELECTRICAL DANGER graphic
and contain instructions that must be followed to avoid an electrical shock. If ignored, severe
injury or death may result and even severe damage to electronic equipment.
Safety First – Before Working on this Equipment
CAUTION
This equipment is designed to be installed in association with volatile
hydrocarbon liquids such as gasoline and diesel fuel. Installing or working on this equipment
means working in an environment in which these highly flammable liquids or vapors are
present. This presents a real risk of severe injury or death if these instructions and standard
industry practices are not followed.
Lock out and Tag circuit breakers before installation or service of this and associated equipment
Restrict access to the work area to only certified and trained installers or service personnel
Identify and mark the perimeter of the work area with signs, safety-cones and colored safety tape
Prevent unauthorized vehicle access (block access) into the work areas by using barriers,
barricades, and service trucks
Use only non-sparking tools when working in these Hazardous Areas
Check for presence of hydrocarbon vapors in containment sumps before entering and periodically
there after.
NOTE