Filter
Top Products
Fan assembly
Valve cover
Control panel
(Fan control location)
Screw hole
Figure 47: Optional Blower (Fan) Installation.
Secondary Installation
INSTALLATION OF OPTIONAL BLOWER:
1. Remove the pre-assembled blower from the packaging. Inspect the blower for damage. If damage is
noticed call your dealer, distributor or courier company and have components replaced.
2. Ensure the temperature sensor will touch the
unit when mounted. If it does not touch, adjust
the sensor so it does.
2. Place the fan assembly behind the unit and
secure with the three screws provided, (as
shown in Figure 47).
3. Open the gas valve cover. Carefully cut the decal
portion on the control panel and install the fan
control switch in this location. See Figure 46 for
wiring of optional blower.
4. Plug the fan assembly into the wall outlet and
turn the unit on to ensure fan operation.
33
INSTALLATION OF LOG SET AND EMBERS:
The placement of the logs is not arbitrary. If they are positioned incorrectly, the ames can be “pinched”
and will not burn correctly. The burner come with four (4) locator pins, and the right log has two (2)
ledges which make alignment easier. Using the pictures provided, carefully set the logs in place.
Placement Pin for Left Rear Log
Ledge for Left Rear Log
Figure 48: Step 1 of Log Placement.
Figure 49: Step 2 of Log Placement.
NOTE: The logs are fragile and
should be handled gently.
CAUTION: Use only the type of
ember material supplied with this
appliance. Due to the irregular
size of the ember material there
may be more than required. The
use of other foreign materials on
the burners may create dangerous
conditions.
If over time, through cleaning and
servicing, these embers require
replacement, contact the nearest
ENVIRO dealer for replacement
embers.