Filter
Top Products
Maintenance And Service
TO BE INSTALLED BY A QUALIFIED SERVICE AGENCY ONLY
FUEL CONVERSION:
Warning: This conversion kit shall be installed by a qualied service agency in accordance
with the manufacturer’s instructions and all applicable codes and requirements
of the authority having jurisdiction. If the information in these instructions is not
followed exactly, a re, explosion or production of carbon monoxide may result
causing property damage, personal injury or loss of life. The qualied service agency
is responsible for the proper installation of this kit. The installation is not proper or
complete until the operation of the converted appliance is checked as specied in the
manufacturer’s instructions supplied with the kit.
Please read and follow these instructions. Also, please read the instruction guidelines provided by S.I.T.
on how to remove and install the HI/LO regulator.
Step 1. Carefully inspect all parts supplied with this conversion kit.
Step 2. Shut the gas supply off at the shut-off valve. (CAUTION: The gas supply shall be shut off prior
to disconnecting the electrical power, before proceeding with the conversion.)
Step 3. Remove the glass as shown in the MAINTENANCE AND SERVICE - OPENING THE DOOR.
Using a " deep
socket remove/reinstall
the main burner orifice.
Undo the two
(2) screws that
hold burner in
the firebox.
Rotate handles
and remove the
door and glass.
Lift off the pilot
head and replace
with proper pilot
orifice for fuel type
to be used.
Venturi adjustment
bracket.
Pilot assembly moved
from firebox for clarity.
Figure 9: Unit burner shown apart.
10
Step 4. Carefully remove the log
set and ember material if
they are installed.
Step 5. Remove the two (2)
screws (located on the
outside edges of the
burner) that hold the
burner to the chassis
inside the re box, see
Figure 9. Remove the
burner tray from the
rebox.
Step 6. Change the regulator on
the front of the gas valve
(follow the instructions
provided by S.I.T.).
Step 7. To change the pilot,
simply pull the pilot hood
straight up to access the
pilot injector. Using a
5
/
32 inch Allen key, remove
the pilot injector and
replace with the proper
fuel type needed.