Filter
Top Products
Daniel 3818 LNG Liquid Ultrasonic Meter Installation Manual Section 4: Configuring a 3818 LNG Meter
3-9000-771 Rev A May 2012
Using a Field Communicator to configure the meter 79
5. Wire Analog Input 1 (AI1) and Analog Output 1 (AO1) as shown in Figure 4-22.
Figure 4-22 Field Communicator wiring diagram for the 3818 LNG Meter
6. Use the leads provided with the Field Communicator to connect to your device.
7. Press and hold the
Power button on the Field Communicator until the green light
blinks.
8. Use the touch screen on the Field Communicator, the keypad or use the stylus to
navigate through the device menus.
9. Refer to the Menu tree in Section D.1.1 of the Daniel HART Field Device Specification
manual (P/N 3-9000-762) for the device fast key sequences. Included in the menu tree
are:
• Diagram Page 1 - 3810 Series Root Menu; Overview, Configure>Manual Setup
• Diagram Page 2 - Configure>Manual Setup (continued) and Alerts Setup
• Diagram Page 3 - Service Tools>Alerts and Variables
• Diagram Page 4 - Service Tools>Variables (continued), Service Tools>Trends, and
Service Tools>Maintenance
10. If you encounter problems, refer to the contact information on the back cover of this
manual or the contacts included in the Field Communicator Users Manual.