Filter
Top Products
Daniel 3818 LNG Liquid Ultrasonic Meter Installation Manual Section 4: Configuring a 3818 LNG Meter
3-9000-771 Rev A May 2012
Using AMS Device Manager to configure the meter 73
14. Click the Service Tools tab to access the device alerts, variables, trends and maintenance
statuses or to edit the configuration parameters.
a. Click the
Service Tools|Alerts tab. If an alert condition exists, the alert type and
description displays. Recommended actions are listed to assist you in a
resolution. After you resolve the alert condition, click the
Acknowledge button to
clear the alert. Click
Apply to write the changes to the meter. If no alert condition
is active, click
OK to close the device window.
Figure 4-16 AMS Device Manager - Service Tools Alerts
b. If you change the device configuration, a confirmation dialog displays and
prompts you to write the changes to the meter. Click
Yes to write the changes to
the meter or click
No to cancel pending changes.
Figure 4-17 Configuration changes dialog