Filter
Top Products
www.desatech.com
111245-01C24
INSTALLING LOGS
CAUTION: Do not remove the
-
CAUTION: After installa-
With the heater set to HI, check
-
It is very important to install these logs exactly
as instructed. Do not modify logs. Only use logs
supplied with heater.
1. Locate pegs on the bottom of back log (#1).
Slide these pegs into the holes in the grate base
behind the burner (see Figure 41).
2. Place the base of the middle log (#2) in the
U-shaped slots of the grate base in front of the
back log. The cutout on the right of the middle
log should t over the burner (see Figure 42).
Make sure the front of the middle log is resting
on the tabs of the grate base and the cutout area
is centered over the burner “U” bend.
3. Locate the notches in the bottom of the front
log (#3). Place the front log on the grate ngers.
Make sure the notches of the front log line up
with the grate ngers (see Figure 43).
4. Place left crossover log (#4) across logs #1, #2
and #3 tting holes on bottom of log #4 onto pin
on front and middle logs as shown in Figure 44.
5. Place right crossover log (#5) in the same manner
on right side of logs (see Figure 44, page 25).
INSTALLATION
Continued
Figure 43 - Installing Front Log (#3)
[CGEFP Logs Shown]
Front Log (#3)
Grate
Fingers
Notches
Figure 42 - Installing Middle Log (#2)
[CGEFP Logs Shown]
Middle
Log (#3)
Cutout
Tab
Burner
"U" Bend
U-shaped
Slot
Figure 41 - Installing Back Log (#1)
[CGEFP Logs Shown]
Burner
Hole in
Grate Base
Back
Log (#3)