Desa CGEFP33PRB Indoor Fireplace User Manual


 
www.desatech.com
111245-01C30
TROUBLESHOOTING




Note: All troubleshooting items are listed in order of operation.

1. Battery in remote control is ei-
ther missing or has low power
2. Remote control is not pointed
toward replace
3. Manual ignition bypass
switch not in OFF position
4.
No power available to replace
5. Ignitor electrode not con-
nected to ignitor cable
6. Broken ignitor cable
7. Ignitor electrode broken
8. Ignitor electrode positioned
wrong
1. No power available to
fireplace
2. Manual ignition bypass
switch not in OFF position
3. Wall switch wire harness is
disconnected
1. Burner orice clogged
2. Inlet gas pressure is too low
1. Manifold pressure is too
low
2. Burner orice clogged
1. Burner orice is clogged or
damaged
2. Damaged burner
3. Gas regulator defective
REMEDY
1. Replace battery in remote
control
2. Point remote control toward
lower front panel of replace
when operating
3. Place manual ignition bypass
switch in OFF position
4. Make sure power cord is
plugged into electrical outlet
and outlet has power
5. Reconnect ignitor cable
6. Replace ignitor cable
7. Replace pilot assembly
8. Replace pilot assembly
1. Make sure power cord is
plugged into an electrical
outlet and outlet has power
2. Place manual ignition bypass
switch in OFF position
3. Check continuity of wall
switch wire harness. Make
sure plug on wall switch wire
harness is fully inserted into
socket on circuit board in re-
place. Replace if necessary
1. Clean burner (see Cleaning
and Maintenance, page 29) or
replace burner orice
2. Contact local gas company
1. Contact local natural or pro-
pane/LP gas company
2. Clean burner (see Cleaning
and Maintenance, page 29) or
replace burner orice
1. Clean burner (see Cleaning
and Maintenance, page 29) or
replace burner orice
2. Replace damaged burner
3. Replace regulator

When buttons on remote control
are pressed, there is no response
from replace
When wall switch button is
pressed, there is no response
from replace
Burner does not light after ODS/
pilot is lit
Delayed ignition burner
Burner backring during com-
bustion