Filter
Top Products
www.desatech.com
111245-01C12
4
3
/4"
3
3
/4"
3/8"
3/16"
3/4"
3/8"
Diameter
2 Holes
8. Remove paper template from wall.
9. Drill 3/8" holes at each mark.
10. Using a straight edge and pencil, connect the
outer edges of the 4 holes for the rectangle (see
Figure 10). This will give you cutting lines for
the rectangle you will cut in the wall.
11. Using a keyhole saw, hack saw blade, drill,
le or other suitable tool, carefully cut out the
rectangular opening. Note: The corners of the
rectangle may be round. IMPORTANT: Do not
exceed the size of the rectangle on template.
12. From inside the recessed opening for the
replace, carefully pass wall switch assembly
through the rectangular opening to the outside
of the wall.
13. Using wall anchors supplied in hardware pack-
age, fold wall anchor as shown in Figure 11.
14. Insert wall anchor, wings rst, into hole. Tap
anchor ush to wall.
15. For thin walls (1/2" or less), insert red key into
wall anchor. Push red key to “pop” open anchor
wings. See Figure 12. IMPORTANT: Do not
hammer key! For thick walls (over 1/2" thick),
do not pop open wings.
INSTALLATION
Continued
16. Position wall switch assembly vertically over
wall openings with decal lettering upright (see
Figure 13).
17. Insert mounting screws, removed in step
2 of Relocating Wall Switch Assembly on
page 10, through holes in wall plate and
into wall anchors.
18. Tighten screws until wall plate is rmly at-
tached to wall. Do not overtighten.
Figure 13 - Securing Wall Switch
Assembly
Screws
Wall Switch
Assembly
Opening in Wall
or Mantel Wall
Figure 11 - Folding
Anchor
Figure 12 - Popping
Open Anchor Wings
for Thin Walls
Figure 10 - Using Template for Wall
Switch Assembly Installation
Template
from This
Manual
Cutting
Lines
Make
Marks at
Centers
of Holes
Tape
of Mantel
7. Create three openings in the mantel wall ac-
cording to Template 2, page 41. This is best
done by making a pattern to work with on the
mantel. Carefully cut page 39/40 from manual
and tape paper template vertically onto mantel
wall at preferred location. Pierce the paper at
the centers of the 2 holes with a nail or sharp
pencil, leaving a mark on the wall. Do the
same at centers of the four circles near the
corners of the rectangle.
8. Remove paper template from mantel wall.
9. Drill 1/8" pilot holes at each mark for top and
bottom screw holes. Drill 3/8" holes at each
mark for centers of four circles near corners
of rectangle.
10. Using a straight edge and pencil, connect the
outer edges of the 4 holes for the rectangle (see
Figure 10). This will give you cutting lines for
the rectangle you will cut in the mantel wall.
11. Using a keyhole saw, hack saw blade, drill,
le or other suitable tool, carefully cut out the
rectangular opening. Note: The corners of the
rectangle may be round. IMPORTANT: Do not
exceed the size of the rectangle on template.
12. Carefully pass wall switch assembly through
rectangular opening from inside mantel (see
Figure 13).