Filter
Top Products
www.desatech.com
118531-01A6
• When locating termination cap, it is important
to observe the minimum clearances shown in
Figure 7, page 8.
• If recessing into a wall, you can avoid extra
framing by positioning your replace against
an already existing framing member.
• Do not recess termination cap into a wall or
siding.
• You may paint the termination cap with 450ºF
(232ºC) heat-resistant paint to coordinate with
the exterior nish.
• There must not be any obstruction such as
bushes, garden sheds, fences, decks or util-
ity buildings within 24" from the front of the
termination cap.
• Do not locate termination cap where excessive
snow or ice build up may occur. Be sure to
clear vent termination area after snow falls to
prevent accidental blockage of venting system.
When using snow blowers, do not direct snow
towards vent termination area.
PRE-INSTALLATION
PREPARATION
Continued
This direct-vent gas replace heater is packaged
with:
• one box containing a 4 piece log set located on
the burner in the rebox.
• one bag containing the owner’s manual with
installation instructions, operator’s guide, and
warranty information.
• one bag of glowing ember material.
• one bag of vermiculite hearth treatments.
Remove the shrink-wrap securing the 2 carton
trays to the unit. Lift the top carton tray off and
remove the 4 corner posts. Discard the bottom tray
once the unit is moved into position.
CLEARANCES
Minimum clearances to combustibles for the re-
place are as follows:
Back and sides* 0"
Perpendicular walls 12"
Floor 0"
Ceiling to louver opening 40"
Front 36"
Top of Standoffs 0"
Vent Surfaces 1" (See venting
instructions for
s pe c if ic v en t
clearances.)
Mantel Clearances ( S e e M a n te l
Clearances, page 8
for specifics on
mantel clearances.)
*Combustible material with a maximum thick-
ness of 5/8" may be ush with the top front of
replace.
-
-
FRAMING AND FINISHING
Figure 4, page 7, shows typical framing of this
replace. Figure 5, page 7, shows framing for
corner installation. All minimum clearances must
be met.
For overall unit dimensions, framing allowances
and vent collar locations, see Figure 6, page 7.
For available accessories for this replace, see
Accessories on page 39. If you are using a separate
combustible mantel piece, refer to Figures 7 and
8, page 8 for proper height and clearances. You
can install noncombustible mantels at any height
above the replace.
Note: Noncombustible mantels may discolor!
Figure 3 - Fireplace Bottom Dimensions
15"
36"
25"