Filter
Top Products
www.desatech.com
118531-01A34
-
-
Glass must be cleaned periodically. During start up
it is normal for condensation to form on the inside
of the glass causing lint, dust and other airborne
particles to cling to the glass surface. During initial
start up a slight lm may form on the glass due to
paint curing. The glass should be cleaned several
times with a non-ammonia, nonabrasive household
cleaner and warm water after the rst two weeks of
operation. Thereafter, clean the glass two or three
times during each heating season, depending on the
usage and circumstances present. Refer to Remov-
ing/Replacing Glass Door, page 25 of this manual
when removing glass door for cleaning.
-
(see Replacement Parts
-
If glass has been broken, carefully remove glass
door (see Removing/Replacing Glass Door, page
25). Vacuum all glass pieces with a shop vac.
CAUTION: Do not vacuum if
Use only the tempered glass door replacement
intended for this replace (see Replacement Parts,
page 38 for detail on ordering). No substitutions
may be made. See Removing/Replacing Glass Door,
page 25 for instructions for replacing glass door.
• Remove ember material before cleaning burners
and replace when cleaning is complete.
• Burner and controls should be cleaned with
compressed air to remove dust, dirt or lint.
• Use a vacuum cleaner or small, soft bristled
brush to remove excess dust, dirt or lint.
LOGS
• If you remove logs for cleaning, refer to Install-
ing Logs, Lava Rock and Glowing Embers, page
27, to properly replace logs.
• Use a vacuum cleaner to remove any carbon
buildup on logs.
• Replace log(s) if broken. See Replacement
Parts on page 38.
• Replace ember material periodically as needed.
See Replacement Parts on page 38.
VENTING SYSTEM
Conduct annual inspection of the venting system
following these guidelines:
1. Check areas of venting system that are ex-
posed to the weather for corrosion (rust spots
or streaks and, in extreme cases, holes). Have
these items replaced immediately by a quali-
ed service person.
2. Remove the vent cap and shine a ashlight
into the vent. Remove any foreign material.
3. Check for evidence of excessive condensation.
Continuous condensation can cause corrosion
of caps, pipes and ttings and can be caused
by having excessive lateral runs, too many
elbows or exterior portions of the system being
exposed to cold weather.
4. Inspect joints to verify that no pipe section or
tting has been disturbed and loosened. Check
mechanical supports such as wall straps for
rigidity.
CLEANING AND
MAINTENANCE
Continued