Filter
Top Products
Item Indicator, button, or
connector
Icon Description
Non-redundant
power supply
One 450 W non-redundant
AC power supply.
NOTE: Non-redundant
power supply is
supported in systems
with cabled hard drives
and systems with an x8
backplane.
2, 6, 8 USB connectors (6) Allows you to connect USB devices to the system.
Five ports are USB 2.0-compliant and one port is
USB 3.0-compliant.
3 System identification
button
The identification buttons on the front and back
panels can be used to locate a particular system
within a rack. When one of these buttons is
pressed, the LCD panel on the front and the
system status indicator on the back flash until one
of the buttons is pressed again.
Press to toggle the system ID on and off.
If the system stops responding during POST, press
and hold the system ID button for more than five
seconds to enter the BIOS progress mode.
To reset iDRAC (if not disabled in F2 iDRAC setup),
press and hold for more than 15 seconds.
4 iDRAC port (optional)
Dedicated management port on the iDRAC ports
card.
5 System identification
connector
Allows you to connect the optional system status
indicator assembly through the optional cable
management arm.
7 vFlash media card slot
(optional)
Allows you to insert a vFlash media card.
9, 12 Ethernet connectors (2) Two integrated 10/100/1000 Mbps NIC
connectors.
10 Video connector Allows you to connect a VGA display to the
system.
11 Serial connector Allows you to connect a serial device to the
system.
13 PCIe expansion card slots
(6)
Allows you to connect up to six full-height PCI
expansion cards.
21