Filter
Top Products
Steps
1. Align and insert the tabs on the iDRAC ports card on the slots on the chassis wall.
2. Insert the iDRAC ports card into the connector on the system board.
3. Secure the iDRAC ports card using the two captive screws.
Next steps
1. Install the internal cooling fan.
2. Install the cooling shroud.
3. Follow the procedure listed in After working inside your system.
Related Links
Removing the cooling shroud
Removing the internal cooling fan
Installing the cooling shroud
Installing the internal cooling fan
Removing the iDRAC ports card
Replacing an SD vFlash media card
1. Locate the SD vFlash media slot at the back of the chassis.
2. To remove the SD vFlash media card, push the card inward to release it, and pull the card from the
card slot.
Figure 44. Removing and installing the SD vFlash media card
1. SD vFlash media card 2. SD vFlash media-card slot
3. To install an SD vFlash media card, insert the contact-pin end of the SD vFlash media card into the
card slot on the module.
NOTE: The slot is keyed to ensure correct insertion of the card.
4. Press the card inward to lock it into the slot.
107