Filter
Top Products
61
14. Changing functions using the DIP switches
LK3-B448E MARKII/BA-16
q
DIPA-1
DIPA-2
DIPA-3
DIPA-4
DIPA-5
DIPA-6
DIPA-7
DIPA-8
Motion when set to ON
See “12-2. Setting the presser
mode”
Presser does not automatically lift after sewing is
completed.
Two-pedal mode is available.
User program mode is available.
–
The presser does not rise automatically when a split is found.
Displays the enlargement/reduction ratio in millimeter units instead of as a percentage.
(After changing this setting, be sure to carry out the auto-clear operation by referring to
page 38.)
Enlargement of pattern size is not available.
Program number is fixed.
Switch
ON
ON
DIPA-2
ON
ON
Pedal specifications
Single pedal
Single pedal
Two pedals
Two pedals
Raising the presser at the sewing end
Presser is raised automatically.
Presser is raised by pressing the pedal.
Presser is raised automatically, then it is lowered by
pressing the pedal.
Presser is kept lifted while the pedal is pressed.
DIPA-1
14. Changing functions using the DIP switches
14-1. Operation panel DIP switches
The operation panel DIP switches q are used to change
functions which might need to be changed depending on
the sewing conditions.
NOTE:
Always turn off the power before setting the DIP switches.
The functions shown in the table below can be changed
by means of these DIP switches.
* All DIP switches are set to OFF at the time of shipment.
14-2. Setting the presser mode
Through the combination of DIP switches A-1 and A-2 on the operation panel, presser motions can be set as follows: