Filter
Top Products
LK3-B448E MARKII/BA-16
8. Sewing
33
8. Sewing
Before starting sewing...
•
Check that the needle bar is at its highest position.
Turn the machine pulley so that the index mark q on
the pulley is between the marks
w
on the belt cover.
* If the stop position of the machine pulley is not correct,
error [E-50] will be displayed, because the wiper may
come into contact with the needle and this may cause
the tip of the needle to break.
Once sewing is completed and the thread has been trimmed, the button clamp will rise.
* Depending on the sewing data, thread trimming may be carried out or the button clamp may rise during
sewing, but the rest of the sewing will still be carried out automatically.
5.
Turn on the power switch
(The POWER indicator will illuminate and the program number will flash in the display.)
1.
CAUTION
Turn off the power switch at the following times, otherwise the machine may operate if the foot switch
is depressed by mistake, which could result in injury.
• Threading
• When replacing the bobbin and needle
• When not using the machine and when leaving the machine unattended
Do not touch any of the moving parts or press any objects against the machine while sewing, as this
may result in personal injury or damage to the machine.
2.
Install the button.(Press the MANUAL switch.)
3.
Place the material to be sewn under the button clamp, and then depress
the foot switch.
When the foot switch is pressed to the 1st step, the button clamp will lower.
If you would like to shift the position of the material, release the foot switch.
The button clamp will then rise again.
4.
1st step
2st step
Depress the foot switch to the 2nd step.
The feed mechanism will move to the starting
position and the button clamp will rise.
* Note that if the foot switch is pressed to the 2nd step while the display is
illuminated, the machine will start operating.
q
w