Filter
Top Products
LK3-B448E MARKII/BA-16
3. Installation
20
Attach all safety devices before using the
sewing machine.
If the machine is used without these devices
attached, injury may result.
CAUTION
q
e
w
q
3-21 . Installing the motor cover
1. Install the motor cover q to the motor back cover w
with the screws e and the flat washers r.
2. Pass the motor shaft through the notch in the motor
back cover w, and then tighten the screws y and
the washers u so that the clearance between the
motor pulley t and the motor cover q is uniform.
3-22 . Installing the spool stand
Assemble the spool stand q while referring to the spool
stand instruction manual, and then install the spool stand
q at the right side of the work table.
3-23 . Installing the eye guard
Install the eye guard assy w to the face plate q with the
two screws e.
w
q
e
r
t
y
u