Filter
Top Products
22
4. Lubrication
LK3-B448E MARK2/BA-16
Turn off the power switch before starting lubricating, otherwise the machine may operate if the foot
switch is depressed by mistake, which could result in injury.
Be sure to wear protective goggles and gloves when handling the lubricating oil and grease, so that they do
not get into your eyes or onto your skin, otherwise inflammation can result.
Furthermore, do not drink the oil or eat the grease under any circumstances, as they can cause vomiting
and diarrhoea.
Keep the oil out of the reach of children.
CAUTION
4. Lubrication
NOTE :
●
Fill the machine with oil when the oil level is down to about one-third full in the oil sight glass.
If oil is not added and the oil drops below this level, there is the danger that the machine may seize during operation.
●
Be sure to let the machine operate for a while after adding the oil.
●
Use only specified Brother oil (Nisseki Sewing Lube 10) for the machine oil.
4-1 . Lubrication points
1. Fill the arm-side oil tank with oil.
* When setting up the sewing machine and when it
hasn’t been used for an extended period of time, be
sure to add 2-3 drops of oil at the place indicated by
the arrow.
2. Fill the bed-side oil tamk with oil
4. If using the liquid cooling tank w, fill it with silicon oil
(100 mm
2
/s).
3. Add oil to the felt q of the shuttle race base.
* When setting up the sewing machine and when it
hasn’t been used for an extended period of time, be
sure to add 2-3 drops oil to the felt.
q
w